Tips for Cork installations

Tips for Cork installations.

When installing cork on boards or walls, follow these tips to ensure a successful installation.

Here are some tips to follow:

1. Prepare the surface: Before installing the Portugal cork, ensure the surface is clean, dry, and smooth. Remove any bumps, cracks, or debris to ensure the pin adheres appropriately.

2. Measure and cut the cork: Measure the area you want to cover with a pin and cut the sheet to the appropriate size using a sharp utility knife. Please leave a little extra cork around the edges to ensure a snug fit; you can trim it off later.

3. Apply adhesive: Apply a thin layer of glue to the back of the cork sheet and the surface it is applied using a roller or brush. Make sure to spread the adhesive evenly to prevent any bumps or lumps from forming, and make sure the glue has covered all areas. (contact cement spray or brushable can work the best)

4. Place the cork: Carefully place the sheet onto the surface, starting at one corner and working your way across. Smooth out any wrinkles or bubbles as you go.

5. Secure the cork: Once it is in place, use a roller or other tool to press it firmly onto the surface. Ensure the cork is securely attached to the surface, especially around the edges.

6. Allow to dry: Allow the adhesive to dry completely before using the cork. This may take several hours or overnight, depending on the type of adhesive used. By following these tips, you can ensure a successful installation of cork on boards or walls.